SaniAlarm Installation Instructions
Install this top-mounted alarm in a few simple steps:
- use a 5mm drill bit to place a guidance hole, and then gradually use a 10mm bit to drill the insertion hole.
- pinch the plunger tube and gradually fit it through the hole until its flange rests on the top of the lid.
- use some silicone to create a tight seal (optional)
- push the pressure controller into the plunger tube until the alarm box makes contact with the top of the lid.
Works with Most Saniflo Models
This alarm accessory is suitable for use with all the models in the SaniPLUS, SaniPRO, SaniBEST, SaniGRIND, SaniPACK and SaniVITE product lines. The lids are labeled with faint ‘alarm’ lettering to indicate the optimum point for drilling/installation.
The unit is powered by two 1.5 V batteries and requires no additional power input
NOTE: Saniflo recommends using a SaniAlarm for all behind the wall pump installations.
Warranty: 2-Year Full Manufacturer Warranty
provides On-site SaniAlarm installation.